Manual
Table Of Contents
- Start Up Guide
- Getting Started
- Checklist
- 1. Power up the Core and connect a PC
- 2. Access the basic Core configuration
- 3. Install a Software Upgrade Licence key (Optional)
- 4. Configure the Core for Surface Panels
- 5. Configure Network Switches & Devices
- 6. Configure Surface panels ID, IP addresses & Subnet masks
- 7. Connect Surface Switch & Surface Panels to the Core
- 8. Access Assist setup and create a new show
- 9. Connect to Assist from the Studio or Management subnets
- 10. Upload control layouts to the soft panels
- 11. Create layouts with Type R Soft Panel Designer
- 12 Update System Software & AoIP Devices Firmware
- 13. Configure AoIP Port & Connect server IP addresses
- 14. Connect Audio Switch and AoIP Ports to the Core
- Surface Panels - Suggested Settings
- AoIP Network Interfaces - Suggested Settings
- About Type R manuals
- User Notes
8 TYPE R Radio Production System Start Up Guide
1. To Log in to Configure, open your Web browser e.g. Chrome and browse to the address of the LAN port you are connected to e.g the
Setup port on the core of the unit which by default is 172.16.255.19 this will open up the Configure Login page shown above.
2. In order to access the Configure Application, the user will need to enter the Username and Password, the user then taps on the
‘Log in’ button and the Configure application then accesses the Home menu as shown at the top of the next page
3. Click on System. The System>General Configuration page will be displayed, as shown at the bottom of the next page.
4. Set the system date & time.
5. You may also set new System and Core names here. These names will be used by the system to identify and announce cores,
as well as in system status messages, so it is important for all the cores you own to be given unique names.
2. ACCESS THE BASIC CORE CONFIGURATION
Calrec Configure Login Instructions
From version 1.4 of the Impulse applications and version 2.0 of the Type R applications, security passwords have been put in place,
there are currently two fixed Roles/Accounts available, the normal Operator account and an Engineer account which provides
technician access to extra configuration functionality. For the Operator account, the Username should be entered as ‘Operator’ with
the Password ‘calrec’. Note: both the Username and Password are case sensitive.
CORE CONFIGURE LOGIN PAGE