Manual
Table Of Contents
- Start Up Guide
- Getting Started
- Checklist
- 1. Power up the Core and connect a PC
- 2. Access the basic Core configuration
- 3. Install a Software Upgrade Licence key (Optional)
- 4. Configure the Core for Surface Panels
- 5. Configure Network Switches & Devices
- 6. Configure Surface panels ID, IP addresses & Subnet masks
- 7. Connect Surface Switch & Surface Panels to the Core
- 8. Access Assist setup and create a new show
- 9. Connect to Assist from the Studio or Management subnets
- 10. Upload control layouts to the soft panels
- 11. Create layouts with Type R Soft Panel Designer
- 12 Update System Software & AoIP Devices Firmware
- 13. Configure AoIP Port & Connect server IP addresses
- 14. Connect Audio Switch and AoIP Ports to the Core
- Surface Panels - Suggested Settings
- AoIP Network Interfaces - Suggested Settings
- About Type R manuals
- User Notes
25
Calrec Connect Login Instructions
1. Open your Web browser e.g. Chrome and browse to the address of the LAN port you are connected to e.g the Setup port on the
core of the unit which by default is 172.16.255.60. This will launch Connect, which opens the Connect Login page shown below.
CALREC CONNECT LOGIN PAGE
2. In order to access the Connect Application, the user will need to enter the Username and Password, the user then taps on the
‘Log in’ button and the Connect application then accesses the Devices menu as shown at the top of the next page.
3. Clicking on calrec-system shows the 2 Type R core AoIP port pairs ready for creating Transmit and Receive streams to/from
the core as shown at the top of the next page.
4. Clicking on each of the AoIP Devices such as the Combo AoIP Device shows the Type R IO Box AoIP port pair ready for
creating Transmit and Receive streams to/from each AoIP device as shown at the bottom of the next page.