Manual
Table Of Contents
- Start Up Guide
- Getting Started
- Checklist
- 1. Power up the Core and connect a PC
- 2. Access the basic Core configuration
- 3. Install a Software Upgrade Licence key (Optional)
- 4. Configure the Core for Surface Panels
- 5. Configure Network Switches & Devices
- 6. Configure Surface panels ID, IP addresses & Subnet masks
- 7. Connect Surface Switch & Surface Panels to the Core
- 8. Access Assist setup and create a new show
- 9. Connect to Assist from the Studio or Management subnets
- 10. Upload control layouts to the soft panels
- 11. Create layouts with Type R Soft Panel Designer
- 12 Update System Software & AoIP Devices Firmware
- 13. Configure AoIP Port & Connect server IP addresses
- 14. Connect Audio Switch and AoIP Ports to the Core
- Surface Panels - Suggested Settings
- AoIP Network Interfaces - Suggested Settings
- About Type R manuals
- User Notes
19
Application
Setup Port
(front of core)
Management subnet
(back of core)
Studio A subnet
(surface panels)
Assist 172.16.255.25 172.29.1.1 172.17.1.1
Calrec Connect 172.16.255.60 172.29.1.21 172.17.1.21
Software Updater 172.16.255.40 172.29.1.22 172.17.1.22
Configure 172.16.255.19 172.29.1.23 172.17.1.23
To access the
Assist, Core Configure & Calrec Connect applications, from the various connection points in the system type the
corresponding IP address shown in the table below into the Google Chrome address bar address bar.
IP ADDRESSES FOR ACCESS TO ASSIST, CONNECT, SOFTWARE UPDATER & CONFIGURE USER INTERFACES
SURFACE PANEL CONFIGURATION WITH ASSIST PC CONNECT OPTIONS TO SETUP, MANAGEMENT & STUDIO A