Manual

16 TYPE R Radio Production System Start Up Guide
2. In order to access the Assist Application, the user will need to enter the Username & Password, the user then taps on the ‘Log in’
button and the Assist application then accesses the Fader Surface page with the menu selector, as shown at the top of page 17.
To create a new Show from here follow these steps:
3. From the menu down the left side of the page go to Shows & Snapshots then click on the Shows submenu.
4. In the footer menu select New, the Create new Show dialogue box will be displayed.
5. Select the Default_Show template show and click Next.
6. Fill in the form to label and describe your Show, then click on Create to create a new show as shown at the
bottom of page 17.
You will be automatically redirected to the Fader layout screen as shown at the top of page 18.
7. From here you may begin to configure your mixer with DSP paths, routing etc.
However we would recommend that you continue to complete the setup before doing this.
8. ACCESS ASSIST SETUP AND CREATE A NEW SHOW
Calrec Assist Login Instructions
1. Open your Web browser e.g. Chrome and browse to the address of the LAN port you are connected to e.g the Setup port on the core
of the unit which by default is 172.16.255.25 this will launch Assist, which opens the Assist Login page shown below.
CALREC ASSIST LOGIN PAGE