Datasheet

23
WHITE AND IVORY KNOBS AND PLATES
For use with 25-351, 25-351A, 25-339, 25-339A, 25-357, and 25-357A. Plates have numbers 0-10. Knob is
1
5
/16” in diameter and accepts
1
/4” shafts.
85-565-ID Ivory Designer Style Knob
85-565-WD White Designer Style Knob
28-140-W White Wall Plate
25-356
10 WATT 70 VOLT MONO ATTENUATOR
10-step attenuation for high level audio signal. Low insertion loss. Controls up to 10 watts of speaker load.
Handles 70 volts RMS input. Stainless steel panel. Easy installation. Comes with terminal block connectors.
White wall plate and knob with pointer.
25-361
8 OHM STEREO MULTIPLE SPEAKER ATTENUATOR
12 step design for a total attenuation of 42dB. Matches impedance to amplifier and allows 1 to 16
attenuators to be used with one amplifier. Selectable index washer under knob for setting attenuation.
Power handling 100 watts, 200 watts peak, 8W output. White insert and knob with pointer. Accepts up to 14
awg cable. Removeable terminal blocks, 2.7” deep.
25-362
30 WATT 70 VOLT MONO ATTENUATOR
Click type 70 volt attenuator with isolation transformers. (10) step 8-3dB, 2-6dB steps for attenuation. Comes
with terminal block connectors. White insert and knob with pointer. Accepts up to 14 awg cable, 2.3” deep.
28-145
COLORED DESIGNER STYLE INSERT COVERS
Designed to be used with the Calrad 25-360, 25-361and 25-362 attenuators. Easy to remove designer
style insert comes with matching colored knob.
28-145-AL............Almond
28-145-BK...............Black
28-145-WH.............White
28-145-IV................Ivory
25 Series - Desktop Volume Controls & Transformers
CALRAD
25 Series - Speaker Attenuators & Accessories
Visit Calrad on the Web at: www.calrad.com