Installation Guide
Table Of Contents
- Contents
- About this Guide
- Intended Audiences
- Federal Communications Commission (FCC) Statement
- Safety Notices
- IMPORTANT SAFETY INSTRUCTIONS
- Key Attributes - BLAST u4 Home Gateway
- WI-FI
- GigaSpire Mesh BLAST u4m Overview
- Agency Listing
- Site Preparation
- Before you Begin
- Introduction
- Installation Variables
- Unpacking the GigaSpire u4/u4m
- Tabletop Mounting Dimensions
- Wall Mounting Dimensions
- Tabletop Mounting the u4/u4m
- Wall Mounting the u4/u4m
- Additional Mounting Considerations
- Powering the BLAST u4/u4m
- Connecting to the Internet
- LED States - Power Off & Boot-up
- LED States - BLAST LED Status
- LED States - Samsung Smart Things
- LED States - Mesh Mode
- Wall Mount Template
Proprietary Information: Not for use or disclosure except by written agreement with Calix.
.
36
LED States - Samsung Smart Things
Samsung Smart Things
Description
Colors
Indication
ST Hub Ready for Setup
Red & Green Flashing
LED green and Red cycles at
500 msecs.
Once set-up, reverts to gateway
previous status
If set-up is not successful,
consult Error states under Smart
Things
Set-up Error
Flashing Red
If Set-up is not successful, cycle
red @ 500 msec,
continue flash for 30 secs, then
revert to the gateway previous
status
Searching for Sensor
Flashing Green
During search for sensor, LED
cycles green @ 500 msec. If
sensor is found, the LED reverts
to gateway previous status. If
the sensor is not found, the
blinking continues for 60 secs,
then reverts to gateway previous
status