Installation Guide
Table Of Contents
- Contents
- About this Guide
- Intended Audiences
- Federal Communications Commission (FCC) Statement
- Safety Notices
- IMPORTANT SAFETY INSTRUCTIONS
- Key Attributes - BLAST u4 Home Gateway
- WI-FI
- GigaSpire Mesh BLAST u4m Overview
- Agency Listing
- Site Preparation
- Before you Begin
- Introduction
- Installation Variables
- Unpacking the GigaSpire u4/u4m
- Tabletop Mounting Dimensions
- Wall Mounting Dimensions
- Tabletop Mounting the u4/u4m
- Wall Mounting the u4/u4m
- Additional Mounting Considerations
- Powering the BLAST u4/u4m
- Connecting to the Internet
- LED States - Power Off & Boot-up
- LED States - BLAST LED Status
- LED States - Samsung Smart Things
- LED States - Mesh Mode
- Wall Mount Template
Proprietary Information: Not for use or disclosure except by written agreement with Calix.
.
33
Powering the BLAST u4/u4m
The information below describes the powering of any GigaSpire BLAST.
1. Locate the 12 VDC Power Adapter.
2. Attach one end (2-pin barrel connector) to the rear of the BLAST u4/u4m.
3. Plug the other end into any available 110/220 VAC wall outlet.
4. The GigaSpire BLAST begins its start-up sequence (Flashing blue LED).
GigaSpire BLAST u4/u4m Power Connection
To power up the BLAST u4 or u4m