User manual

User Manual – Rev B FCS Series II
ENTRY DESCRIPTION
for backward compatibility with California
Instrument’s original FCS Series AC power
source.
If APE is installed, the language mode can be
selected over the bus or from the
CONFIGURATION screen. (see section
4.2.9).
ADVANCE ON Adds arbitrary waveforms and harmonic
measurements. This feature is optional. If
installed, this field will display ON. If not, N/A
is shown instead.
N/A If –ADV option is not installed, N/A is shown.
MODE ON Allows the output to be switched between
single and three phase modes of operation.
This feature is optional. If installed, this field
will display ON.
N/A If –MODE option is not present, N/A is shown.
CLOCK/LOC N/A Clock and lock is an option. If no –LKM option
is installed, this field will show N/A.
MAST -LKM Option installed. The unit can be used
as a Clock and Lock system master or stand
alone.
AUX -LKS option installed. The unit can be used as
a Clock and Lock system auxiliary or stand
alone.
Elapsed Time and Temperature Screen 4.2.12
The Etime/Temp screen displays the elapsed time since the power source has first been turned
on. This is an accumulated total time in hours, minutes and seconds.
The same screen also displays the internal temperature of the power supply.
ENTRY DESCRIPTION
ETIME 01:23:45 The ETIME field displays the total
accumulated elapsed time for the instrument
since it's initial manufacture. This value
cannot be changed or reset.
California Instruments 73