User manual

User Manual – Rev B FCS Series II
ENTRY DESCRIPTION
NO OUTP Selects SINGLE or THREE phase mode of operation. In SINGLE
phase mode, all current is delivered to the ø1 and COM terminals of
the OUTPUT terminal block.
Note that even in SINGLE phase mode, a voltage is present at ø2
and ø3 terminals. Connect only a single phase load when operating
in single phase mode.
ST PHASE Selects the start phase angle for output changes made to either
gram the output voltage up to the set level after the
d
± 360°. To set to RAND,
voltage or frequency. This allows changing the output at a specific
phase angle. The Output on/off key also uses this phase angle
setting to pro
output relay is closed. The default value for this field is RAND. To
set the start phase angle, set the cursor to the ST PHASE field an
use either shuttle knob to adjust between
use the BACK key.
California Instruments 61