User manual

User Manual – Rev B FCS Series II
4.2.2 Top Level Menus
The following top-level menu choices can be accessed using the Menu key:
ENTRY DESCRIPTION
PROGRAM The PROGRAM menu allows primary output parameters such as
voltage, frequency, current limit, waveform shape and voltage
range to be changed.
CONTROL The CONTROL menu allows secondary setting parameters su
as phase mode and
ch
ALC mode to be changed.
MEASUREMENTS The MEASUREMENT screen is not a menus in that no user
entries are required. It displays read-back data.
TRANSIENTS The TRANSIENTS menu allows output transients to be
programmed.
REGISTERS The SETUP REGISTERS menu allows complete instrument
settings and transient list programs to be saved to nonvolatile
memory.
CONFIGURATION The CONFIGURATION menu allows changes to be made to
configuration settings such as the IEEE-488 address, RS232C or
USB/LAN internal baudrate, LAN settings, power on state and
Master/Auxiliary control mode.
OUTPUT CAL
angle and Calibration password entry. If the correct calibration
The OUTPUT CAL menu provides access to the LCD viewing
password is entered, additional Calibration screens can be
accessed.
MEAS CAL The MEAS CAL menu allows for calibration of the AC source
measurement system.
APPLICATIONS
e installed in the FCS
The APPLICATIONS menu provides access to the optional
firmware application programs that may b
Series II AC source.
OPTIONS The OPTIONS menu provides access optional functions that may
be present on the FCS unit.
ETIME/TEMP t The ETIME/TEMP screen displays the Elapsed time (Time the uni
has been in operation) in hours, minutes and seconds. It also
displays the internal temperature of the unit in degrees Celsius.
LIMITS The LIMITS screen display the hardware configuration limits of the
n AC power source. It is for display purposes only and the user ca
change none of these fields.
California Instruments 55