User manual

User Manual – Rev B FCS Series II
3.10 Remote Control Interfaces
Setup and connection information on setting up remote control using either GPIB, RS232, U
or LAN interfaces is provided in the Lx/Ls Series II Programming Manual P/N 7004-981. Thi
SB
s
manual is distributed on the same CD ROM (P/N CIC496) as this user manual. It can also be
downloaded from the California Instruments website (
www.calinst.com).
Connector pin out information is provided in sections 3.6.6, 3.6.8 and 3.6.9 of this manual.
control more than one power source from a single PC is Note: Use of the USB port to
not recommended, as r
multiple power source control.
communication may not be reliable. Use GPIB interface fo
California Instruments 46