User manual

User Manual – Rev B FCS Series II

3.6.9 LAN Interface – RJ45

An optonal RJ45 Ethernet 10BaseT connector is located on the rear panel for remote control. A

standard RJ45 UTP patch cord between the AC Source and a network Hub may be used to

connect the AC source to a LAN. For direct connection to a PC LAN card, a crossover RJ45

cable is required. Consult your network administrator for directions on connecting the AC source

to any corporate LAN.

If the –LAN Ethernet interface option is present, the MAC Address (Media Access Control) of the

Ethernet port is printed on the serial tag of the power source. The serial tag is located on the

rear panel of the unit.

ies Programming Manual P/N 7004-981 distributed in Adobe PDF

format on CD ROM CIC496.

For information on how to set up a network connection or a direct PC connection using the LAN

interface, refer to the Lx/Ls Ser

LAN

Pin # Ethernet TPE

10BaseT/100BastT/1000BaseT

EIA/TIA 568A EIA/TIA 568B

Crossover

1 Transmit/Receive Data 0 + White with green strip White with orange stripe

2 Transmit/Receive Data 0 - Green with white stripe or Orange with white stripe or

solid green solid orange

3 Transmit/Receive Data 1 + White with orange stripe White with green stripe

4 Transmit/Receive Data 2 + Blue with white stripe or

solid blue

Blue with white stripe or

solid blue

5 White with blue stripe Transmit/Receive Data 2 - White with blue stripe

6 Transmit/Receive Data 1 - Orange with white stripe

or solid orange

Green with white stripe o

solid

7 Transmit/Receive Data 3 + White with brown strip or

solid brown

White with brown strip or

solid brown

8 Transmit/Receive Data 3 - Brown with white stripe or

solid brown.

Brown with white stripe or

solid brown

Table 3-12: RJ45 LAN Connector pin out.

California Instruments 41