User manual

User Manual – Rev B FCS Series II
Number Message String Cause Remedy
-300 e specific error" Hardware related
error
"Devic Check hardware for proper operation.
-311 "Memory error" Waveform memory
checksum error.
May be the result of incomplete user-
defined waveform download. Check
L:ALL
command to clear waveform memory.
interface and try downloading
waveform again. Successful
download may clear this error
condition.
Alternatively, use TRAC:DE
-314 "Save/recall memory User setup register
contents lost
Store setup in same register again.
lost"
-315 "Configuration memory Hardware
configuration settings
lost.
t CI service department at
lost"
Contac
[e-mail] to obtain
instructions on restoring configuration
data.
-330 "Self-test failed" Internal error
[e-mail]
Contact CI service department at
suppor
-350 "Queue overflow" Message queue full. tus
dicating queue
Too many message. Read sta
using SYST:ERR query until 0, "No
Error" is received in
empty.
-400 y error" lete Check programming manual for
correct query format and parameters
"Quer Unable to comp
query.
-410 "Query INTERRUPTE Check application program for correct
flow. Response must be read after
each query to avoid this error.
D" Query issued but
response not read.
-420 "Query
UNTERMINATED"
Query incomplete. Check for terminator after query
command.
-430 "Query DEADLOCKED" Query cannot be
completed
Check application program for
multiple queries
-440 "Query
UNTERMINATED"
Query incomplete. Check for terminator after query
command.
0 "No error" No errors in queue
2 " Non-volatile RAM
CONFIG section
checksum failed"
Controller failure
during Self-test.
Contact CI service department at
[e-mail]
3 " Non-volatile RAM CAL
section checksum failed"
Controller failure
during Self-test.
Contact CI service department at
[e-mail]
4 " Non-volatile RAM
WAVEFORM section
checksum failed"
Controller failure
during Self-test.
Contact CI service department at
[e-mail]
10 "Ram self test Controller failure
during Self-test.
Contact CI service department at
[e-mail]
40 "Voltage self test error,
output 1
No. 1/A amplifier in
Master source has no
output during Self-
test.
Contact CI service department at
[e-mail]
41 "Voltage self test error,
output 2
No. 2/B amplifier in
Master source has no
output during Self-
test
Contact CI service department at
[e-mail]
California Instruments 204