User manual

User Manual – Rev B FCS Series II
11.8.3 LxGui MS704 Performance Test Screen
Note: For AC sources without the –ADV option installed, the harmonic analysis and
waveform acquisition functions described in this section are not available.
Contact
[e-mail] to upgrade the FCS AC Source with the –ADV op
The MIL-STD 704 stimulus can still be run however.
tion.
Revision F of the MIL-STD 704 provides additional detail on performance evaluation of the EUT
groups. The FCS Series AC source with the –ADV option provides built-in measurement
functions ate EUT p
Note how mum bandwidth r ment for current harmonic measurements of
the FCS Series II is limited to 48KHz in single-phase mode and 16 KHz in three-phase range.
Harmoni fall outside this ba th are not reported (value of 0.00 is
returned)
The requirement for MIL-STD 704 is 150 KHz so for EUT’s with high harmonic order currents, a
higher bandwidth external power analyzer should be used in addition to the AC source.
after running an immunity test. This is covered in test method 101 of each of the power test
that can be used to evalu erformance.
ever that the maxi equire
c components that ndwid
.
F i MS704 Option EUT Performance Test Screen - Measurements igure 11-14: LxGu
California Instruments 193