User manual

User Manual – Rev B FCS Series II
11.6 Front Panel Operation MS704
This section covers operating the –704 option from the front panel keyboard. For remote control
operation, refer to the Lx/Ls Series II Programming Manual (P/N 7004-981).
To perform a test from the keyboard, from the MENU 2 screen, select the APPLICATIONS
screen. The APPLICATIONS screen will appear as shown in Figure 11-1.
he MS704 entry using the up and down cursor keys. Press
the ENTER key to select the MS704 main menu.
Fig
L704 Run/Status
Note: or to s urn on the Output relay and set the desired steady
state output settings for the test. Also select iate parameters that define revis
and te ype b
The RUN field has two parameters that can be selected by the shuttle, SINGLE and CON
croll to the RUN entry using the up and down cursor keys. Use the shuttle to change the
Key to Run the test. The screen will appear as shown in Figure 11-3
The status line will show the type of test that is running followed by the Test condition and the
remain time on. Test condition may be repeated several tim
before oving terminate the test once the test
conditi is com e test only when all remaining test
conditi is com
ote: Several of the MIL-STD 704 test steps take considerable time to execute. Tests in
Figure 11-1: Applications Menu
Use the ENTER Key and scroll to t
The Run/Status screen will appear shown in
ure 11-2.
Figure 11-2: MI
Pri tarting any tests, you must t
the appropr io , n
st t efore starting the test.
T.
S
selection. Use the ENTER
while the test is running.
Figure 11-3: Mil704 Run/Status
ing to complete the test conditi es
m to the next test condition. Run Single will
terminate thon pleted. Run Continuous will
on pleted.
N
progress may be aborted by using the BACK button on the front panel.
California Instruments 141