User manual

User Manual – Rev B FCS Series II
10.6 Steady State Tests
Scroll to the STEADY STATE entry using the up and down cursor keys. Press the ENTER ke
select the STEADY STATE screens. The scre
y to
en will appear as shown in Figure 10-3
Figure 10-3: Steady State Menu
6. FREQ MODULATION
7. VOLT TRANSIENT
8. FREQ TRANSIENT
9. DISTORTION
hlighted selection using the up and down
cursor keys and the ENTER key to start the selected test.
VOLTAGE
The MIL704 Steady state screens have the following tests:
1. VOLTAGE
2. FREQUENCY
3. VOLT UNBALANCE
4. PHASE DIFFERENCE
5. VOLT MODULATION
The above tests can be selected by scrolling to the hig
This test will change the output voltage in the sequence shown in Table 10-1.
SEQUENCE VOLTAGE TIME
400Hz/VFREQ 60Hz only
1 108 110 1 minute
2 118 125 1 minute
3 115 115 1 minute
Table 10-1: Steady state voltage
The key (backspace) will terminate the test at any time.
FREQUENC
This test will change the output frequency in the sequence shown in Table 10-2.
←
Y
SEQUENCE FREQUENCY TIME
California Instruments 132