User manual

User Manual – Rev B FCS Series II
9. Option –160: RTCA/DO-160 Rev E Tests (Software)
U
• -160 option. Options installed are listed on unit’s serial tag or shown on Configuration
screen.
• Windows XP/2000 PC with RS232C, LAN or National Instruments GPIB controller
interface. California Instruments recommends the use of the GPIB interface for best
performance.
vionics Software user manual (CI P/N 4994-971) for operating instructions for all
GUI based test options. This manual is distributed in PFD format on the same CD as this user
manual. (CI P/N CIC496).
se of this option requires the following:
• FCS Series
1
II Power Source.
• LxGui Windows software revision 1.14 or higher. Provided on CI P/N CIC496 CD ROM
or available for download from California Instruments’ website.
• For specific tests, additional test equipment may be required to perform all section 16
tests.
Refer to the A
his DO160 Rev E implementation uses arbitrary waveform capabilities and harmonic measurements, both
require the –ADV (advanced features) option on the FCS Series II. Contact California Instrumen
1
Note: T
of which ts for
information on upgrading FCS Series II models with the –ADV option.
California Instruments 128