Instruction manual

73
3.7.5.20.TO TALK THE MEASURED OUTPUT POWER (TLK PWR)
PWR may be used as an argument to the header TLK with an A, B or C extension. When used
as an argument, it will set up the AC Power System to measure the output power in kilowatts.
When PWR is used as a header in a string with no argument, it will cause the front panel to
display the output power.
3.7.5.21.TO TALK THE MEASURED OUTPUT POWER FACTOR (TLK PWF)
PWF may be used as an argument to the header TLK with an A, B or C extension. When used
as an argument, it will set up the AC Power System to measure the output power factor from 0
to 1.000.
When PWF is used as a header in a string with no argument, it will cause the front panel to
display the output power factor.
3.7.5.22.TO TALK THE MEASURED OUTPUT APPARENT POWER (TLK APW)
APW may be used as an argument to the header TLK with an A, B or C extension. When used
as an argument, it will set up the AC Power System to measure the Apparent Power output in
KVA.
When APW is used as a header in a string with no argument, it will cause the front panel to
display the measured output Apparent Power.
3.7.5.23.TO TALK THE MEASURED OUTPUT FREQUENCY (TLK FQM)
FQM may be used as an argument to the header TLK. There are no extensions for this
argument. When FQM is used as an argument, it will set up the AC Power System to measure
the output frequency in hertz.
When FQM is used as a header, it will cause the front panel to display the measured output
frequency.