Instruction manual

64
HEADER EXTENSION ARGUMENT DEFINITION
TRG Execute (Trigger) set-up
parameters on GPIB "GET"
message.
VAL From parameter
minimum to maxi
mum value
Final ramp or step value in volts,
hertz, amps, degrees,sine wave or
square wave.
OPN Open output relays.
CLS Close output relays.
VLT A, B, C Used with TLK to request
measurement of the output voltage.
ELT Used with TLK to request total
accumulated run time.
CUR A, B, C Used with TLK to request
measurement of the outputload
current.
MOD PHS 1 or 3 Program the output phase
configuration
PWR A, B, C Used with TLK to request
measurement of the True out put
power.
APW A, B, C Used with TLK to request
measurement of the Apparent
output power.
PWF A, B, C Used with TLK to request
measurement of the output power
factor.
PZM A, B, C Used with TLK to request
measurement of the output phase
angle.
FQM Used with TLK to request
measurement of the output
frequency.
NOTE: If Extension does not follow the header, the argument will be applied to
all phases .