Manualshelf

Instruction manual

ManualsBrandsCalifornia Instruments ManualsConsumer electronicsFCS Series II
31323334353637383940
33
Table 3-4: Keypad Key Description
KEY DESCRIPTION
SNW/0 Inputs the value "0" for all output parameters or to select screen "0" when
followed by the ENT key. Also used to select sine wave waveform.
SQW/1 Inputs the value "1" for all output parameters or to select screen "1" when
followed by the ENT key. Also used to select the square wave waveform.
INT/2 Inputs the value "2" for all output parameters or to select screen "2" when
followed by the ENT key. Also used to select the Internal Synchronize or
Internal Clock modes of operation.
EXT/3 Inputs the value "3" for all output parameters or to select screen "3" when
followed by the ENT key. Also used to select the External Synchronize or
External Clock modes of operation.
4
through
9
Inputs the indicated numeric value for all output parameters or to select the
corresponding screen when followed by the ENT key.
MNU/. Selects the Menu screens that show all display screens and the corresponding
numeric value. The decimal point function of this key is enabled after any
numeric key is depressed.
A Used to direct any parameter change to phase A. Also used to update any
quantity in the display identified as A=.
B Used to direct any parameter change to phase B. Also used to update any
quantity in the display identified as B=.
C Used to direct any parameter change to phase C. Also used to update any
quantity in the display identified as C=.
↑/REG
Used to increment the value in any output parameter screen or calibration
screen. Also used to load the program register into any register identified by
the preceding numeric value.
↓/REC
Used to decrement the value in any output parameter screen or calibration
screen. Also used to recall the program register identified by the preceding
numeric value.
CLR/SRQ Used to clear the numerical inputs for the display screen.
MON Used to display programmed output parameter values. Used repeatedly, it
will cause the display screens of increasing numeric numbers to be
displayed.
PRG Used to program setup values in the Program Register. Used repeatedly, it
will cause the display screens of decreasing numeric numbers to be
displayed.
ENT Used to transfer the contents of the program register to the actual output
parameters.