Instruction manual

1000-1200 1 ±0.005% 60 Hz

(Limited to 1000 for HV4)

* Phase Angle 0 - 360° 0.5° ±3° B=240 C=120

* Current Limit 0 to Full- 0.5A to +5 to +15% Maximum

Scale 200

Current 5.0A above 200 +5 to +15%

Voltage Stability (24 Hrs) 0.25% FS, 15 minute warm-up

Features

• 1ø, 3ø operation - user configurable for single cabinet, factory/field configurable by

manufacturer for multi-cabinet systems.

• Remote Sense - allows correction for load wiring losses (up to 2% at full load).

• Parallel Capability - operate 6 KVA amplifiers in parallel to increase output power

capability.

• External Sync Input - causes output signal to track this input in frequency and phase. A

5 volt, 45 to 1200 Hz, 5 milliamp, TTL type signal. Loss of this input forces the output

to the fault mode.

• Indicators - Power On

• Module Failure

• Overtemp

• Output Fault

• Status Reporting

• Field Power Upgrades (by manufacturer) - cabinets may be added up to three total in a

system; two or three cabinet systems may be converted 1ø to 3ø or 3ø to 1ø.

• Ramp/Sweep of Voltage, Frequency, Phase and Current Limit up to 2 functions

simultaneously.

• Storage Registers - store up to 16 setups.

• Calibration - perform either via front panel keypad or IEEE488 bus.