Instruction manual

123
Press MNU to
Select Test
The MNU screen has two lines of selection shown at a time.
There are 3 different types of operations that can be selected from a MENU acreen. If the word
MENU appears for the item selected, another MENU screen will be displayed. If the word TEST
appears for the item selected, the test will start. The display will return to the previous screen if
the word RETURN appears for the item selected.
The Main Menu will appear as follows:
1=Steady St Menu
2=Transient Menu
3=Abnormal Menu
4=Emergency Menu
5=MIL704D Test
6=Return
If key 1 is selected "Steady State: from the Main Menu, the following Menu will appear:
1=Voltage Test
2=Unbalance Test
3=Phase dif Test
4=Wave dist Test
5=Frequency Test
6=Steady St Test
7=Return
If key 2 is selected "Transient" from the Main Menu, the following Menu will appear:
1=Volt Trns Menu
2=Freq Trns Menu
3=Transient Test
4=Return
If key 1 is selected from the Transient Menu the following Menu will appear:
1=High Volt Test
2=Low Volt Test
3=Volt Trns Test
4=Return