User manual

L-Series and FCS-18 Graphical User Interface User Manual
Rev C - June 1996 California Instruments 97
Make sure the Windows international settings use a dot (.) as the decimal
separator, not the comma (,) which is normally used in Europe. To check
and change this, select the International Icon in the Windows control panel.
2. Next, install the National Instruments GPIB-TNT or PC/IIA Windows
drivers using the Windows disk. The DOS drivers are not required but may
be installed if desired. This is done by running the Setup program from the
NI disk labeled “NI-488.2 Software for Windows, Distribution Disk for the
EISA-GPIB, the AT-GPIB/TNT, and the AT-GPIB” or the equivalent disk
supplied with the PC/IIA card.
3. Once the installation is completed, open the Windows Control panel
and select the GPIB icon (NI logo). This brings up the hardware configuration
screen. Use the settings shown below: