User manual

L-Series and FCS-18- Graphical User Interface User Manual
66 California Instruments Rev C - June 1996
7.7 Transient execution
Transient execution can be started by clicking on the
button. The register shown in the “Start from Reg:” drop down list will be the
first one executed. Select the desired register number before pressing the
button. If this register is linked to other registers, execution will
proceed according to the link sequence. (Refer to section 7.3)
The button can be used to stop transients in progress. This
may not always work immediately and an error message may pop up
indicating the attempt to stop the transient in progress was unsuccessful.
Clicking the button several times usually resolves this
problem.