User manual

L-Series and FCS-18 Graphical User Interface User Manual
Rev C - June 1996 California Instruments 13
3.3 Installed files
The installation program will install the following files in the directories
specified. Note that files with the same name that already exists in these
directories will be overwritten as part of the installation process. As long as
the files being overwritten are of an older date (previous version), this should
not cause any problems. If however you have newer versions of some of
these files, we recommend you back these files up prior to running the
installation program and then restore them afterwards.
Application directory files:
The following files are copied to the application directory. The application
directory name is chosen by the user at the time of installation. In this
manual, the default application directory name LSGUI is used.
path and filename size in bytes date
.\lsgui\lsgui.exe 216438 9/15/95
.\lsgui\lsgui.hlp 62601 9/13/95
.
Windows system directory files:
The following support files are copied to the windows system directory:
path and filename size in bytes date
.\windows\system\fpgrid10.vbx 409200 5/12/95
.\windows\system\cmdialog.vbx 18688 4/28/93
.\windows\system\spin.vbx 22528 10/21/92
.\windows\system\threed.vbx 64432 7/17/93
.\windows\system\mhtip.vbx 35040 7/21/95
.\windows\system\mhrun400.ddl 94352 7/21/95
.\windows\system\commdlg.ddl 89248 3/10/92
.\windows\system\gpib.ddl 90624 8/31/94
.\windows\system\ver.ddl 9696 10/5/94
.\windows\system\setupkit.ddl 7008 4/28/93
.\windows\system\vbrun300.ddl 398416 6/3093