User manual

User Manual Compliance Test System 3.0
JP11JP13
11
Address DIP
Normal Mode
(Factory Setting)
Diff. Mode
JP11
1
1
4
4
JP11
Figure 3-20: A/D Card JMP 11 Settings
Pin 19 = DAC
Pin 19 = Ground
(Factory Setting)
JP13
JP13
1
1
3
3
Figure 3-21: A/D Card JMP 13 Settings
Jumper JP11
Jumper JP11 selects between differential or single ended input channel mode and should be set
to single ended mode for the CTS system. The correct setting is shown in Figure 3-20. Pin 1
and 2 are jumpered together as are pins 3 and 4. This is the setting in which the board is
shipped from the factory and you should not have to change it.
California Instruments Revision N 57