User Manual

ManualsBrandsCalifornia Faucets ManualsWater equipmentVessel Deck Faucets (1-Handle)

CF-XX01-1_ii_100601.doc Pg 2

INSTALLING POP-UP DRAIN

• Remove COLLAR (12) from pop-up assembly and apply

SILICONE CAULK (13) (or equivalent) to underside of

COLLAR (12)

CAUTION: Do not use or any oil base sealant that may damage finish

• Insert DRAIN BODY (15) from underside through sink

DRAIN HOLE (14) & attach to COLLAR (12)

• Align BALL ROD HOLE (15a) toward LIFT ROD (4) and

firmly tighten FLANGE NUT (18) against FRICTION

WASHER (17), MACK WASHER (16) and sink DRAIN

HOLE (14)

• Remove TAILPIECE (19) from DRAIN BODY (15), apply

thread sealant to TAILPIECE (19) threads and tighten

into DRAIN BODY (15)

• Insert STOPPER (11) into COLLAR (12) & rotate EYE-

SCREW (11a) to accept BALL ROD (20)

NOTE: If necessary, adjust stopper eye-screw height by loosening LOCK

NUT (11b) and rotating EYE-SCREW (11a), retighten LOCK NUT (11b)

• Remove spring CLIP (23) from BALL ROD (20)

• Remove NUT (22) and both CONE WASHERS (21)

from DRAIN BODY (15) and place on BALL ROD (20)

as shown

• Insert BALL ROD (20) with CONE WASHERS (21) into

BALL ROD HOLE (15a) and through EYE-SCREW (11a)

• Tighten NUT (22), but allow BALL ROD (20) to freely

move up and down

• Place STRAP (24) onto LIFT ROD (4) and tighten

THUMB-SCREW (24a)

• Place one end of CLIP (23) onto BALL ROD (20), then

STRAP (23), gently squeeze CLIP (23) and slide other

end of CLIP (23) onto BALL ROD (20)

• Check proper operation of STOPPER (11) and adjust by

sliding STRAP (24) on LIFT ROD (4)

SUPPLY & WASTE CONNECTIONS

• Connect blue colored FLEX HOSE (7) to cold SUPPLY

VALVE (25) and red colored FLEX HOSE (7) to hot

SUPPLY VALVE (25)

IMPORTANT: Flush supply lines and valves prior to installation to prevent

damage and malfunction of cartridge

• Connect waste P-TRAP (26) to drain TAILPIECE (19)

NOTE: Supply valves and P-Trap are not supplied with faucet. See CAL

TRIM for complete selection of matching products in desired finish

• Turn on cold and hot SUPPLY VALVES (25)

• Slowly open faucet lever by lifting lever and rotate to left

and right

• Check all connections for leaks and repair as necessary

• Give these instructions and Blue Plastic Aerator Key to

consumer for safe keeping

NOTE: Occasionally, due to water conditions it may be necessary to

remove aerator and clean debris off with soft bristle toothbrush

www.calfaucets.com

5231 Argosy Ave. Huntington Beach, CA 92649

800-822-8855