Manual

ManualsBrandsCalifornia Faucets ManualsWater equipmentTile Styledrain Set with No-Hub

StyleDrain

9190, 9190-3, 9190-IP-2, 9190-IP-3,

9190-ABS & 9190-PVC

StyleDrain

Tile

™

(patent pending)

Installation Instructions

9190_ii_121022.doc Pg 1

CALIFORNIA FAUCETS RECOMMENDS THAT ALL PLUMBING PRODUCTS BE INSTALLED

BY A LICENSED PROFESSIONAL

IMPORTANT: Read all instructions prior to installation and provide copy of instructions to consumer. This installation

instructions sheet is a guide for installing StyleDrain

Tile

™

, all local building and plumbing codes as well as manufactures

waterproofing material MUST be followed to achieve proper installation and meet all code requirements

Collar Up Collar Down

Tile

aterproo

Membrane

Earth/Ground

Concrete

ood Sub-floo

Morta

Floo

Joist

ood Sub-Floo

Concrete Sub-Floo

All figures show 2” cast iron no

hub connection

Summary of content (4 pages)

PAGE 1
StyleDrain® 9190, 9190-3, 9190-IP-2, 9190-IP-3, 9190-ABS & 9190-PVC StyleDrain® Tile™ (patent pending) Installation Instructions CALIFORNIA FAUCETS RECOMMENDS THAT ALL PLUMBING PRODUCTS BE INSTALLED BY A LICENSED PROFESSIONAL IMPORTANT: Read all instructions prior to installation and provide copy of instructions to consumer.
PAGE 2
1 • INSTALLING DRAIN BODY Connect BODY (1) to pre-installed DRAINPIPE (3) via one of the following connections which are not included: o o o o o 2” Cast Iron No-Hub use 2” no-hub SLEEVE (2) 3” Cast Iron No-Hub use 3” no-hub sleeve 2” or 3” Cast Iron IPS use 2” or 3” pipe nipple 2”/3” ABS use ABS solvent cement 2”/3” PVC use PVC solvent cement Ø6-1/4” (Cast Iron) Ø7-5/8” (ABS/PVC) NOTE: It may be necessary to trim excess DRAINPIPE (3) to obtain proper final installation height • For wood sub-floor inst
PAGE 3
• INSTALLING THROAT (OUTER FRAME) To obtain proper height, rotate THROAT (8) to raise or lower (one complete rotation is equal to 1/8” in vertical height) NOTE: When COLLAR (5) is installed in up position an additional 7/8” in height is achieved Shown with Collar Down Shown with Collar Up Adds 7/8” of Height 9190_ii_121022.
PAGE 4
• INSTALLING TILE Place some pea GRAVEL (9) around WEEP HOLES (5a) to prevent MORTAR (10) from blocking WEEP HOLES (5a) IMPORTANT: It is necessary that WEEP HOLES (5a) are open and free of building material to allow for proper water seepage • Use MORTAR (10) to build up height to THROAT (8) taking into account thickness of THINSET (11) and TILE (12) WARNING: Do NOT use harsh chemicals and scouring pads (e.g.