Quick Tips

IMPORTANT
PLEASE READ THIS NOTICE!!!
LUBRICATE WITH (LPS-1) DRY SPRAY OR EQUIVALENT.
1) LOADING THE MAGAZINE:
a. Release the clutch by pushing the button at rear of magazine.
b. Carefully wind the knob at the rear of magazine CLOCKWISE until the follower stops in the feed lips.
c. Load the magazine with GOOD QUALITY BRASS CASE 9MM AMMUNITION ONLY!
d. Flip out the winding lever and wind CLOCKWISE (10 MAXIMUM OR LESS COMPLETE TURNS) (23 MAXIMUM
OR LESS COMPLETE TURNS FOR THE 100 RD MAGAZINES.)
e. If magazine becomes difficult to load, release clutch as needed.
2) BOLT STOP:
a. Pull back SLOWLY on bolt handle while maintaining LIGHT PRESSURE on the bolt stop.
b. The first position that will allow the bolt stop to operate provides a “WINDOW” to check the chamber and
will not feed a round when the bolt stop is released.
c. Press the bolt stop all the way in to SECURE THE BOLT
d. The second position is with the bolt all the way back. In this position, the firearm is cocked and when
released, the bolt will feed a round into the chamber. (AT THIS POINT THE FIREARM MAYBE LOADED.
USE WITH CAUTION)
e. To release the bolt, PUSH on the OPPOSITE SIDE of the bolt stop.
f. If the firearm is jarred, the bolt stop MAY NOT hold, it was DESIGNED FOR TEMPORARY, CONTROLLED USE.
3) SAFETY:
a. To activate the safety, the striker must be cocked by pulling back on the bolt handle. (AT THIS POINT
THE FIREARM MAYBE LOADED. USE WITH CAUTION)
b. Cocking the firearm WILL release the safety.
c. If the firearm is cocked and will not be used immediately PUT ON THE SAFETY, the “S” will be visible.
4) PISTOL GRIP
a. DO NOT attempt to remove pistol grip with gun cocked.
PLEASE READ AND FOLLOW OWNERS MANUAL