Instructions

M-900 / M-950 MAGAZINE LOADER
FOR
CALICO 50 OR
100 ROUND 9mm MAGAZINES
1) Depress Latch (4) and
open Loader
as in Fig. A.
2) P!ace Ammo Tray (9)
filled
with good quality 9mm ammo
(8) carefully
onto
Window
(1)
against (2) with Loader in vertical
position
and the inside
corner
of (9) against the inside corner of
(2).
3) Lay the Loader and Tray of bullets
down
so
that
the
Window
(1) is resting flat
on
a
level
surface,
such as a table.
4) Carefully remove Tray as indicated in Fig. B, which will
leave
the bullets stan-
ding rim down on (1 ).
5) Slowly
close
(3)
as indicated in
Fig.
B, being
careful not to knock
over any
bullets. If any do fall over, just stand them up on (1)
and
continue.
6) When Loader
is closed, Latch will lock. If it does not, carefully open Loader.
Pick
up
any
bullets that may have fallen, stand up
and
close again, or shift
bullets slightly if they "bridge".
7) Stand Loader up, as in Fig. C. You
should see (50) bullets,
rimmed end, ap-
proximately as shown.
8) Release pressure on a 50 or 100 round Magazine by pushing Button at rear
of Magazine,
then crank
Winder
slowly
until Follower enters Feed
Lip area.
9) Insert Magazine
into Well (10) so that the Feed Lip is
adjacent to Rotor (5)
as in Fig. D.
10) Hold onto
Magazine with one hand
and
crank Handle (6) clockwise as shown.
11) Watch bullets feed into Magazine via (5). Release Spring pressure in Magazine as
needed.
12) The Lifter (7) should dislodge bullets that may· 'bridge" between (1) and (2) as
you crank. It is possible that a bullet may tumble. In
this
case, stop loading,
re-stack misaligned bullets
and
continue.
13) Repeat procedure for 100 round Magazine releasing
Spring pressure in
Magazine after loading first (50) bullets.
NOTE:
a) It normally takes 15 seconds to toad (50) bullets.
b) Keep your Loader clean and dry for best performance.
c) DO NOT FORCE CRANK - check for too
much
tension on
Magazine
Spring or
misaligned bullet.
d) Do not try '.o toad more than /50) bullets
into
50 RD Magazine
or (100) bullets into 100 RD Magazine.
FIG. A
FIG. B