Quick Tips

IMPORTANT
PLEASE READ THIS NOTICE!!!
LUBRICATE WITH (LPS-1) DRY SPRAY OR EQUIVALENT.
1) LOADING THE MAGAZINE:
a. Release the clutch by pushing the button at rear of magazine.
b. Carefully wind the knob at the rear of magazine CLOCKWISE until the follower stops in the feed
lips.
c. Load the magazine with GOOD QUALITY BRASS CASE .22LR AMMUNITION ONLY!
d. Release the clutch.
e. Flip out the winding lever and wind CLOCKWISE (17 MAXIMUM OR LESS COMPLETE TURNS.)
f. If magazine becomes difficult to load, release clutch as needed.
2) BOLT STOP:
a. Pull back SLOWLY on bolt handle while maintaining LIGHT PRESSURE on the bolt stop.
b. This provides a window to check the chamber and will feed a round when the bolt stop is
released.
c. To release the bolt, PULL BACK on charging handle and LET GO and this will load a round into
chamber. (AT THIS POINT THE FIREARM MAYBE LOADED. USE WITH CAUTION)
d. If the firearm is jarred, the bolt stop MAY NOT hold, it was DESIGNED FOR TEMPORARY,
CONTROLLED USE.
3) SAFETY:
a. To activate the safety, the hammer must first be cocked by pulling back on the bolt handle. (AT
THIS POINT THE FIREARM MAYBE LOADED. USE WITH CAUTION)
b. Cocking the firearm WILL release the safety.
c. Once firearm is loaded PUT THE SAFETY ON. The “S” will be visible when safety is on.
PLEASE READ AND FOLLOW OWNERS MANUAL