Operating instructions

© Calibre UK Limited Issue 2.41 20
th
May 2014, W: www.calibreuk.com
T:[phone] F: [phone] E: techsupport@calibreuk..com 19
3.5.1. Display Type
Settings: Scaler-Switcher, Projector
The Display Type setting defaults to Projector or to the last set before power down.
Select Projector if you drive a projector and need the warp function and edge blend capability.
Set to Scaler-Switcher if you do not need warp (including Location). The unit defaults to single/unit with
PiP functionality. Multiple unit configurations with auto zoom but without edge blend become available
when switching over to multiple unit mode. The real value of this mode is that the Flicker Filter becomes
available. Also, the default settings for Frame Rate and I/O lock are chosen such that unit has cleanest
switching performance.
3.5.2. Output Mode
Settings: 640x480, 800x600, 1024x768, 1280x768, 1280x800, 1280x1024, 1360x768, 1366x768,
1400x1050, 1440x900, 1600x1200, 1680x1050, 1920x1200, 480i, 576i, 480p, 576p, 1080i, 720p, 1080p
Set up the desired output resolution with output mode. The output mode setting should match the native
resolution of the imaging device to avoid double scaling.
The 3GSDI output does not feature the PC mode resolutions, This is because PC modes are not part of
the international SDI standard. SDI supports only 480i/p, 576i/p, 720p and 1080i/p output modes.
Available SDI output modes are indicated by an SDI connector/BNC symbol in the output mode
selection list box of the OSD. SDI output modes not supported are indicated with this symbol crossed
out red.
The default output resolution as set by the factory or after a user issued factory reset is 720p.
3.5.3. Location
Settings: Front Tabletop, Front Ceiling, Rear Tabletop, Rear Ceiling
The image can be flipped to accommodate different projection scenarios as well as screens mounted
upside down.
3.5.4. Frame Rate
Settings: 60 Hz, 50 Hz, 48 Hz, 24 Hz, Auto
In auto mode the output frame rate follows the input frame rate as configured in the Output Config
menu.
Signals with 24Hz, 25Hz, 48Hz, 50Hz input modes get special treatment, Modes with other refresh rates
are displayed at 60Hz.
24Hz input modes will be output at 24Hz if the output resolution is set to either 720p or 1080p and the
Frame Rate setting in the Output Config menu includes 24Hz, otherwise it is displayed at twice the rate
if the Frame Rate setting in the Output Config menu includes 48Hz. Otherwise a 24Hz input mode is
displayed at 60Hz.
48Hz input modes will be output at 48Hz if the Frame Rate setting in the Output Config menu includes
48Hz. Otherwise it is displayed at 50Hz.
A 25Hz input mode is output at twice the frame rate 50Hz.
An exception to the 24/25Hz input mode treatment is if the output resolution is set to 480i or 480p. 480i
and 480p are always run at 60Hz output rate.
50Hz input modes are displayed at 50Hz output rate.
The output frame rate can also manually set to 24Hz, 48Hz, 50Hz or 60Hz if possible, i.e. such output
modes are available.