TECHNICAL SPECIFICATIONS MP3/WMA PLAYER SECTION Signal to Noise Ratio Channel Separation Frequency Response > 60 dB > 50 dB (1kHz) 60Hz - 15 kHz TUNER FM Frequency range Sensitivity Stereo separation Signal to noise ratio Channel step 87.5-108 MHz 2.8 µV 30 dB 45 dB 50 kHz LINE-OUT Output Impedance 5V (max.) 10k Ohm FRONT AUX IN Frequency Response Sensitivity Impedance 60 Hz - 20 kHz 775 mV 20k Ohm GENERAL Power Supply Speaker impedance Output power Fuse 24V DC (10.
Location of parts and controls 18 9 3 RMD 213 2 6 7 12 10 11 13 19 AUX 15 1. 2. 3. 4. 5. 6. 7. 8. 9. 10. 11. 12. 13. 14. 15. 16. 17. 18. 19.
Installation PRECAUTIONS • Choose the mounting location carefully so that the unit will not interfere with the normal driving functions of the driver. • Avoid installing the unit where it would be subject to high temperatures, such as from direct sunlight or hot air from the heater, or where it would be subject to dust, dirt or excessive vibration. • Use only the supplied mounting hardware for a safe and secure installation. 182mm • Be sure to remove the front panel before installing the unit.
General operations Switching on and off Press any button to switch the device on. To switch off, press and hold the /MU button pressed. Volume Turn the VOL(3) knob to set the volume. Switching mute on / off Press the /MU button briefly to turn the sound off. Press the Muting is cancelled when receiving a PTY or TA station. /MU button again to turn the sound on again. Operating mode Press the MD button to switch between AUX/TUNER/USB/SD mode.
DX / LOCAL - Set reception sensitivity Turn the VOL knob to align the reception sensitivity to national stations (DX) or regional stations (LOCAL). ADJ - Set the time Turn the VOL knob to the right to set the minutes and to the left to set the hours. Note: The device has an RDS-controlled clock. The clock sets itself automatically when the RDS function is enabled and continues to run when the radio is switched off . If you do not receive any RDS signal, you can set the time of day manually.
Disabling / enabling the PTY function • Press the MD button to activate the PTY search. The PTY symbol is shown on the display with the last PTY entry selected (e.g. POP M, Rock M...). Only stations with the PTY ID currently selected are included in the station search. • Press the MD button again to disable the PTY search. PTY is no longer shown on the display.
Search functions Title number search • Press the A/PS button. • Turn the VOL knob to set the first digit of the title number required. • Press the SEL button to confirm the entry and to skip to entry of the second, third or fourth digit. • Press the 1 PAU button to commence playback of the selected title. Title name search • Press the A/PS button twice. The search for title names starts immediately. If no title starting with the digit set is found.
