Operation Manual
RCD 120 • MANUAL
17
BEFORE PLAYING DISCS
Before playing a CD, wipe it off with a clean, dust-free cleaning cloth.
Wipe the disc in the direction of the arrow.
Always insert the CD with the label side facing upwards.
If the CD is inserted with the printed side facing downwards, the device
may be damaged.
Note: If there is already a CD in the CD slot , do not try to insert a second
CD. This may damage the device.
Always hold CDs by the edge. In order to keep the CD clean do not touch
the surface. Pull out the CD as follows.
Do not attach any sticker or adhesive tape on the CD.
Do not expose the CD to direct sunlight or sources of heating.
Do not le
ave CDs in a car if it parked in direct sunlight as that will lead to
a considerable rise in the temperature inside the car.
Note: Do not use any solvents such as petrol or thinning agents. Commercially
available cleaning substances of antistatic spray will damage the device.
Cleaning the CD
02
30
0
PRECAUTIONS
Cho ose the moun ting loc at ion whe re the unit will not inter fere wi th the no rmal
driving function of the driver.
Bef ore final ly instal ling the uni t, co nne ct the wiring tem por ar ily and mak e sure
it is all connected up properly and the unit and the system work properly.
Use onl y the par ts incl uded with the uni t to ens ur e pr oper inst al lation. The use
of unauthorized parts can cause malfunctions.
Con sul t wi th your neares t de al er if ins tallat ion requi res the drilling of ho les or
other mo difications of the vehicle.
Install the unit where it does not get in the driver's way and cannot injure the
passenger if there is a sudden stop. Like an emergency stop.
If installation angle exceeds 30 from horizontal, the unit might not give its
optimu m performance.
Avoid installing the unit where it would be subject to high temperature, such
as from direct sunlight, or from hot air, form the heater, or where it would be
subj
ect to dust, dirt or excessive vibration. Do not expose this equipment
to rain or mo isture.
DIN FRON T-MOU NT (Method A)
Installing the unit
1. Dashboard
2. Holder
After inserting the holder into
the dashboard, select the
appropriate tab according to
the thickness of the dashboard
material and bend them
inwards to secure the holder in
(Fig. 1)
place.
3. Screw
INSTALLATION
(Fig. 1)
1
2
3