Warnings When Driving Keep the volume level Iow enough to aware of the road and traffic conditions. CAUTION In some countries, it's unlawful to operate a vehicle while video is displayed in the driver's viewing area. Please always switch the unit's display to "Font Type Display" mode by pressing the DISP button while driving. For safety reason, the driver should only enjoy / watch the video while the car is in parking mode. When Car Washing Do not expose the product to water or excessive moisture.
Installation Removing the unit INSTALLATION CAUTION 1. Before finally installing the unit, connect the wiring temporarily and make sure it is all connected up properly and the unit and system work properly. 2. Use only the parts included with the unit to ensure proper installation. The use of unauthorized parts can cause mal functions. 3. Consult with your nearest dealer if installation requires the drilling of holes or other modifications of the vehicle. 4.
Connecting the System Wiring Diagram-audio/video Connections SUB-WOOFER OUTPUT BLUE SUB WOOFER SUB-W OUT PINK PARKING BRAKE ( ) Brake Switch Connect to Parking Brake. 2.
Connecting the System Wiring Diagram - Power/Speakers (ISO+Small Connector) FUSE (Not supplied) ANTENNA EXTENDER CABLE ANTENNA JACK BLACK FRONT CHANNEL BLUE/WHITE STRIPE RED YELLOW POWER AMPLIFIER REMOTE L-CH R-CH RED AMP WHITE L-CH REAR CHANNEL (Not supplied) RCA-TO-RCA CABLES WHITE RED R-CH GREY (RED) Ignition wire (ACC) (YELLOW) Battery wire (B+) 20-PIN AUDIO/POWER HARNESS (See Figure 1 ) Connect to power amplifier, If not used, Tape bare end of wire.
Panel Control Operation Panel Open/Close Operation Panel Tilt Adjustment This unit is equipped with the most advanced full logic motorized slide down system. You can enjoy this advance technology with just a single press of the button. Please read carefully the following operation instruction before operating the unit. End user can adjust the panel viewing angle of the display to obtain the optimum viewing angle inside the vehicle.
Name Of Buttons and Theirs Functions EJECT Press this button to eject the Disc. PANEL TILT Long press this button to entering adjust the panel viewing angle. TUNE UP/DOWN Under the tuner mode, press and hold momentarily to enter into the Auto Seek / Manual Seek mode.. & Under the Disc mode, press these buttons to skip a chapter / track / scene / image / file. FAST FORWARD/ Under the Disc mode, press and hold momentarily to fast forward / backward the video disc.
Name Of Buttons and Theirs Functions Remote Control 10 POWER 2 1 8 9 2 DE NE MO ZO 5 11 SOURCE VOLUM E 14 6 17 18 MENU CAPTURE DVD SETUP DVD MENU D F L DISP FUNCTION LIST PB C 3 12 B BAND 15 19 GOTO INFO ZOOM DISC AUDIO 25 ANGLE SUB TITLE 26 TITLE 27 20 21 4 13 24 16 22 7 2 ZONE DIMMER 23 No. Button Item Decriptions Press this button to turn the mute On / Off. POWER 1 POWER ON When the unit is power on, long press this button to turn Off OFF the unit.
Name Of Buttons and Theirs Functions Under the tuner mode, press this button to access the Manual Seek mode. Under the media player mode, press this button fast backward through the music under media player mode. 9 UP/DOWN Use these buttons to move cursor up/down/left/right. LEFT/RIGHT 10 Under the tuner mode, press this button access Auto Seek mode. Under the media player mode, press this button to skip backward of the previous chapter. Under the tuner mode, press this button access Auto Seek mode.
System Menu Operations Main System Menu Sub-W 1. Level:Rotate Volume Knob to adjust the Subwoofer lever from 00 to 12. Long press the Menu ( center vol button ) button to access the System Menu mode, then user can rotate to select the desired mode. There are few menu items for selection: System Setting 2. LPF:Rotate Volume Knob button to adjust the Low pass filter (LPF) as Flat, 80Hz, 120Hz or 160Hz. Bass 1. Level:adjust the Bass level from -06 to +06. 2.C.
System Menu Operations Display Setting Preset EQ Setting Under the Preset EQ Setting, there are have 9 different types of preset equalizer available for user selection. Once access into the EQ menu, rotate the encoder knob to navigate the following EQ setting: FLAT ROCK R&B POP JAZZ DANCE COUNTRY REGGAE CLASSIC Tuner Setting Under the Tuner Setting menu, there have below options for selection: AF TA To change AF On / Off. To change TA On / Off. TA Seek To change TA Seek On / Off.
System Menu Operations Handsfree In this Menu will displayed the list Image Setting of Paired Mobile Phone with this unit. In this menu user can select his/her favor image use as wallpaper on the playback mode. There is two sources of image for selection: My Gallery This unit factory default 10 pre-loaded images. User can select these 10 pre-loaded images set as wallpaper on the playback mode. My Image This unit allows user self-capture from VIDEO or JPEG picture.
Tuner Operation [ S ] SOURCE BUTTON [ L ] LIST BUTTON Press button to select Tuner playback mode then press button as confirm the selection. You can get into the Store List to select the desired staion to Recall. [ ][ ] TUNING UP/DOWN BUTTON [ B ] BAND BUTTON Press the button to change between FM bands and or AM(MW). 1. Long press these buttons to access the Manual Seek mode. 2. Press these buttons to access the Auto Seek mode.
Media Player Operations (Disc/USB/SD Memroy Card) This unit can play various video/audio format which stored into disc/USB or SD Memory card on Media Player. The following chart helps you to check if a disc is supported by this unit, as well as what functions are available for a given disc type. Disc format Disc logo Digital Versatile Discs (DVDs) Unsupported Discs 8 cm Disc CDV, CDI, CDG, LD DVD RAM Note on Region Code DVD players and DVD Video discs have their own Region Code numbers.
Media Player Operations (Disc/USB/SD Memroy Card) General Operation Insert the USB Stick [ S ] SOURCE BUTTON Press button to select Disc, USB, SD Memory Card, then press SEL button to start playback the Media Player. [ ] PLAY/PAUSE BUTTON Press button to suspend music play. Press the pause button again to resume music play. CAUTION This unit does not support any portable Hard disk / drive.
DVD Operations Once a DVD disc is inserted into the unit, the unit will automatically start the playback from the beginning of the disc. [ ] PLAY/PAUSE BUTTON 1. Press this button to pause playback. 2. Press this button again to resume normal playback. 3. Long press this button is forward to the next picture in the video (DVD and VCD only). [ ][ ] TRACK SELECT 1. Press these buttons to skip forward to the beginning of the next or previous chapter. 2.
Dual Zone Operation This unit is equipped with the most advance “Dual Zone” feature. This function is useful if the user would like to select different modes of the Audio and Video output source for Front and Rear Speakers and TFT Screens. For example, user can select to listen to Tuner music for front speakers and rear speaker for DVD movie. To Switch On Dual Zone Mode 1. “Off” is the default setting. 3. The TFT screen will display the Rear Source mode for 10 seconds.
AV-In Mode Select the AV Mode Your can connect up to 2 optional devices, press the button to enter into the AV mode: AV in - 1 = Front panel AV in AV in - 2 = RCA back of unit AV in-1 This unit is allowed to connect with external Audio/Video system such like Digital Camera or Game Console. User can connect the external A/V system thru the A/V in jack on front panel. Tips Be sure to connect Parking Brake connection lead. ( please see more details on “ Wiring Diagram.
Wallpaper Setting Setting the Background Screen (Wallpaper) This unit allows user change the background screen on the playback mode. This function is called wallpaper change. User can select the desire image on the below operation to set as wallpaper. 3. The confirmation display appears as confirmed the image is stored in to MY IMAGE. TIPS Those capture images will store in the SYSTEM MENU_ DISPLAY _MY IMAGE. For details please refer to SYSTEM MENU_ DISPLAY_MY IMAGE.
Highlight Features Motion Pictures Display Mode Standby Display Mode The units have 3 difference types of motion pictures can display on TFT under playback Mode. Press the ' ' button repeatedly can switch between the 3 difference modes Under “Ignition On But Power Off” condition, user can set up the Standby display mode for below: Off: To turn off the unit.
Bluetooth Operations User Guide For Bluetooth 1. When user use our Bluetooth HEAD UNIT, please make sure the mobile phone you use must / does support Bluetooth functions (Headset or Handsfree profiles or both). 2. Before you start to use our Bluetooth HEAD UNIT, please make sure complete pairing with your mobile phone first. Please refer to the user manual, section “PAIRING” for detail “PAIRING” instruction.
Bluetooth Operations TIPS Handsfree Operation Pairing, Connecting And Deleting With A Bluetooth Device When connecting Bluetooth devices at the first time with this unit, a mutual registration is required, this is called “Pairing”. This registration (Pairing) is required only at the first time, as this unit and the other devices will recognize each other automatically from the next time. After the devices are registered (Paired) with this unit.
Bluetooth Operations Searching This Unit for Pairing “from a other Bluetooth Device ”. 1. Set the other Bluetooth device which need to be paired with this unit into “Searching” mode. NOTE To allow this unit searching by the other device, the “VISIBILITY” in the SYSTEM MENU of BLUETOOTH must be set to “SHOW”. Please refer to SYSTEM MENU of BLUETOOTH for more details of how to set the “VISIBILTY” mode.
Bluetooth Operations Connecting – User Can Dis-connect Or Re-connect With The Paired Bluetooth Device By Following Operation NOTE Once any BLUETOOTH device is paired with this unit, user can select this PAIRED device to be connected or dis-connected, this is called “Connecting”. 2. Use to select between “Handsfree” and “Audio Device”.
Bluetooth Operations Dis-Connection Deleting User can disconnect the connected Bluetooth device as follows: 1. Access into the SYSTEM MENU of BLUETOOTH MENU _ Handsfree or Audio Device. User can delete a paired device if it is no longer needed as follows: 1. Access into the SYSTEM MENU of BLUETOOTH _ Handsfree or Audio Device. 2. Use to select between “Handsfree” and “Audio Device”.
Bluetooth Operations 2. Use the to navigate thru the numeric 0-9 *, # & +. Handsfree Phoning Answering An Incoming Call User can press the button to answer / accept the incoming call. 1. When there is an incoming call, the ring tone is output from the car speaker, and the caller number will be shown on the display. If the incoming call has no caller number, the display will shown “UNKNOWN”. 2. Always press the button to answer/ accept the call after display showing the “Caller Number” or “UNKNOWN”. 3.
Bluetooth Operations Auto Answer Mode Making An Redial Call Press the button to access the dial interface and then press to Redial the last number dialed out on the unit. To Activate The Privacy Talking Mode (Incoming Call Transfer Mode) During the talking mode, user can LONG press the button to transfer the phone call from the unit back to the mobile phone for privacy reason. The below display will show on the TFT for 3 seconds after the transfer mode is being activated.
Bluetooth Operations Bluetooth Audio Operation Bluetooth Audio Streaming A2DP (Advanced Audio Distribution Profile) User can listen to music files on an audio device on this unit if the audio device supports A2DP (Advanced Audio Distribution Profile) of Bluetooth Technology. Please read the below instruction before operating the Bluetooth Audio streaming function on this unit.
Bluetooth Operations Operating an audio device with this unit AVRCP ( Audio Video Remote Control Profile ) This unit can perform the following operations with the connecting Audio device which supports AVRCP (Audio Video Remote Control Profile) & only if the Audio device does support AVRCP. 1. Start playing - Every time when user change mode into “BT AUDIO” mode, this unit will automatically send a “PLAY” command via AVRCP to the audio device to command the auto start playing song in the audio device.
Specifications TFT Screen Section Screen Size: 3.5＂(Measured Diagonally) Screen Type: TFT Liquid Crystal Display active matrix Resolution: 320 x 240 DVD / CD Section Compatible Disc/Format Signal to Noise Ratio Dynamic Range Frequency Response Channel Separation See “ Disc Note” for more details description > 90 dB > 90 dB 20Hz to 20Khz +/-3dB 2 Channel (Stereo) >60dB @1khz Video Section Color System Video Output Video Input NTSC / PAL Composite 1.0 Vp-p (+/- 0.2) 75 - ohm Composite 1.0 Vp-p (+/- 0.
Troubleshooting Before going through the check list, check wiring connection. If any of the problems persist after check list has been made, consult your nearest service dealer. Symptom Cause Solution No power The car ignition is not on. The fuse is blown. Replace the fuse. Disc cannot be loaded or ejected Presence of CD disc inside the player. Remove the disc in the player, then put a new one. Inserting the disc in reverse direction. Insert the compact disc with the label facing upward.
