LOCATION AND FUNCTION OF CONTROLS 3 5 PWR 2 11 15 10 CLK AS/PS MODE MUTE 6 14 AF 13 12 TA PTY 9 1 7 MMC/SD/USB/MP3 PLAYER VOL+ SEL BND VOL- SD/MMC 1 2 INT 3 RPT 4 RDM 5 SPECIFICATION GENERAL Supply Voltage Current Consumption Power Output Number of channels Unit Dimensions DC 12V. Negative Ground Max.10A 25Watts X 4 (Measured at DC 14.4 V) 2 STEREO channels. 178[W] X 101.5[D] X 50[H] mm. FM SECTION Frequency range Effective sensitivity I.F Frequency 87.5MHz - 108.0MHz 3uV.
mode), CLK ON/CLK OFF, CLK 12/24 mode. After selecting the desired mode, press the VOL- or VOL+ button to select one setup item of the desired mode. 1) TA SEEK/TA ALARM: TA SEEK mode: when newly tuned station does not receive TP information for 5 seconds, the radio retunes to next station which has not the same station (PI) as the last station, but has the TP information.
5. POWER ON/OFF & MUTE When the unit is power off, the unit comes to on by pressing any button except the EJECT and the RELEASE button. When the unit is power on, press and hold the power button for more than 0.5 seconds, the unit goes into power off mode. When the unit is power on, press the power to switch the MUTE state on/off. 6. LCD Display 7&8.
is on, the previous PTY program and PTY word is displayed on LCD. If there are no keys entered for 2 seconds, previously selected PTY is searched. During 1 loop, if desired PTY is not found, NO PTY is flashed, then return to previous normal radio and PTY word disappear. 13. TA [TRAFFIC ANNOUNCEMENT] BUTTON When press the button, it is activated as TA mode on or off. When TA mode is on(TA is displayed on LCD), it will begin to seek TA station and TA SEEK will be displayed on LCD for a while.
2) When briefly pressing, the radio searches for each preset station in the current band and holds at that preset number for 5 seconds with releasing mute, and then search again. During SD/MMC or USB mode: Press the AS/PS button briefly, it is activated selecting TRACK SEARCH mode: In TRACK SEARCH mode, the LCD will display TRK T 000 and flash the biggest digit 0 that the SD/MMC card or USBstick contain. Then press the VOL+ or VOL- button to select the number of the flashing digit from 0 ~ 9.
