Specifications

MAINTENANCE
49
Tennant 5300 (03–98)
SCRUB BRUSH
The scrub brush should be checked daily for wire
or string tangled around the brush or brush drive
hub. The brush should also be checked for any
damage and wear.
The scrub brush should be replaced if large
amounts of bristles are missing, or if the
remaining bristles’ length is less than 10 mm
(0.38 in).
Cleaning pads must be placed on pad drives
before they are ready to use. The cleaning pad is
held in place by a pad holder.
Cleaning pads need to be cleaned with soap and
water after every use.
REPLACING THE SCRUB BRUSH
1. Turn the machine power off and set the
parking brake if your machine has this
option.
FOR SAFETY: Before leaving or servicing
machine, stop on level surface and turn off
machine.
2. Raise the scrub head with the scrub head
lever.
3. Open the access cover on the front of the
scrub head.
4. Turn the brush until you can see the brush
drive pin.
07326
09525
Home
Find...
Go To..