Instructions

the SLEEP period. The SLEEP time can also be adjusted by pressing the [SLEEP] button (9).
• To switch off the SLEEP timer function during SLEEP mode, press the [SLEEP] button (9) repeatedly till
the OFF option or press the [ON/OFF] button (3).
Note:theSleepTimerfunctioncanbeusedwithoutproblemsincombinationwithasetalarm(s).
Radio operation
• Press the [ON/OFF] button (3) once to turn ON the radio. The radio receives a FM band and the LED display
indicates the frequency. After 3 seconds, the LED display will change back to show the time.
• Adjust the volume by pressing the [VOLUME+/-] buttons (1/2).
• Tune into the desired station by either of the 2 following methods:
- Manual Tuning: Use the [. / ,] buttons (7/8) until the desired station is reached.
- Auto Scanning: Press and hold either the [.] or [,] button (7/8) for more than 2 seconds to start auto scan.
Scanning will stop automatically when a clear radio signal is found. Repeat the same procedure by using the
same button until your desired station is found.
Note: Tostopautoscanning,pressanybuttononce.
• To turn off the radio, press the [ON/OFF] (3)..
Note:Thecurrentstationandvolumelevelwillbememorizedwhentheradioisturnedoff.Onceyouturnon
theradioagain,thememorizedstationwillbebroadcastedatthememorizedvolumelevel.
Preset stations
• In radio mode, tune into a radio station (see above).
• Pressandholdthe[TIME/PRESET]button(4)formorethan2secondsuntilpresetnumberappearsandashes.
• You can then choose the preset position (P01~P10) by pressing the [P- / P+] buttons (5/6).
• Press once [TIME/PRESET] (4) button, or wait 8 seconds, to set the preset.
• Repeat these steps until all 10 are set preset stations, or you can stop earlier of course.
• To recall a memorized preset station press the [TIME/PRESET] button (4) repeatedly till you reached the
desired number.
Note: TheFMfrequencybandcanstoreupto10presetstations.
Back up battery
Insert two CR03 (AAA) batteries (not included) into the battery compartment. In the event of a power
interruption or if unplugged, your time settings will be saved for a short period of time.
ENGLISH