Installation Guide

Questions? [phone]
CaliFloors.com
CALI Cork Flooring Installation Guide
• Pencil
• Tapping block (required)
• Hammer
• Chalk Line
• 3/8” spacers
• Utility Knife
• Table Saw
• Rubber Mallet
• Double Sided Prybar
• Miter Saw
• Tape Measure
Installation
Floating Installation Method
Recommended Tools for Cork Installation
Installing the First Row
3. Cut the final board piece to length and install it in the same manner as the previous piece. Use the extra cut piece
to start your next row if it is longer than 12”
1. Starting from the right with the tongue-side facing the wall, carefully place the first board in place, using spacers to
leave a expansion gap between wall and edges of the plank.
2. Install the second piece by aligning the butt end with the end of the first piece at a 45 degree angle. Softly push the
second piece down until the tongue and groove lock together to secure the joint on the ends. Make sure that the
longsides of the two boards form a straight line. Continue in this manner until reaching the final board in the first
row