Installation Guide

Questions? [phone]
www.CaliBamboo.com
Cali Vinyl Flooring Installation Guide
Installing the first row:
1. Starting from the left with the tongue-side facing the wall, carefully place the first board in place, using spacers to leave
a 1/4” expansion gap between wall and edges of the plank.
2. Install the second piece by aligning the butt end with the end of the first piece at a 45 degree angle. Softly push the
second piece down until the tongue and groove lock together to secure the joint on the ends. Continue in this manner
until reaching the final board in the first row.
3. Cut the final board piece to length and install it in the same manner as the previous piece.
Next Steps:
1. If the cut plank is at least 8” in length, it can be used as a starter piece in another row. If the cut plank is shorter than
8” do not use it. Instead, begin with a new board that is at least 8” in length and allows 8” between the end joints on the
adjacent planks.
2. Position the first board in place by angling it up slightly, pushing forward and interlocking the side tongue. The long side
of the plank should fit snug with no gapping.
3. Install the second plank in the second row by partially disengaging the first plank for the purpose of locking the butt
ends of the first and second plank. Once this is done repeat step 2.
4. Carefully inspect the long edge and short ends of the plank for any gapping before moving on to the plank. If you notice
a gap, STOP, and reinstall the board to ensure a snug fit.
5. Install the remaining boards and rows in the same manner.
6. Cut the last board to size.
7. Whenever practical, use cut pieces from previous rows as the starter board to reduce waste, however, it is a best
practice when doing this to not create a repeating pattern. For a natural look rows and patterns should be staggered.
8. Maintain proper spacing (at least 8”) between end joints for best appearance.
Installation
Page 8