Install Instructions

Technical specifications
Materials
Body: glass reinforced nylon PA66G30
Dirt separator cover: glass reinforced nylon PA66G30
Top dosing point port plug: brass EN 12164 CW614N
Top plug: brass EN 12164 CW614N
Drain screw: brass EN 12164 CW614N
Tee pipe fitting: brass EN 1982 CB 753S
Locking nut for tee pipe fitting: brass EN 12420 CW617N
Internal element: HDPE
Hydraulic seals: EPDM
Drain valve: brass EN 12165 CW617N
CAUTION: If the DIRTMAG
®
separator is not installed, commissioned
and maintained properly, according to the instructions contained in this
manual, it may not operate correctly and may endanger the user.
CAUTION: Make sure that all the connecting pipework is water tight.
CAUTION: When making the water connections, make sure that the
pipework connecting the DIRTMAG
®
is not mechanically over-stressed. Over
time this could cause breakages, with consequent water losses which, in
turn, could cause harm to property and/or people.
CAUTION: Water temperatures higher than 100°F (38°C) can be dangerous.
During the installation, commissioning and maintenance of the DIRTMAG
®
separator, take the necessary precautions to ensure that such temperatures
do not endanger people.
Leave this manual for the user
SAFETY INSTRUCTION
This safety alert symbol will be used in this manual to draw attention to safety related
instructions. When used, the safety alert symbol means.
ATTENTION! BECOME ALERT! YOUR SAFETY IS INVOLVED! FAILURE TO
FOLLOW THESE INSTRUCTIONS MAY RESULT IN A SAFETY HAZARD.
CAUTION: All work must be performed by qualified personnel trained in the
proper application, installation, and maintenance of systems in accordance
with all applicable codes and ordinances.
2