Install Instructions

5
3 Mounting and installing the solar station
1. Remove the front half of the insulation.
2. Hold the solar station against the wall and mark the fastening holes (see figure).
3. Fasten the solar station to the wall with the enclosed anchors and screws.
4. Connect the solar station to the solar thermal system.
5. Check the inlet pressure of the expansion tank and, if necessary, adjust it to the local
conditions (inlet pressure = 15 psi + difference in height between the collector and solar
station/10).
6. Connect the electrical components of the solar station: Attach the storage tank and collector
sensor and connect these to the controller. Plug the controller into a socket.
In the case of solar stations without controllers connect the controller and the pump in
accordance with the manufacturer’s instructions.
7. Tighten all union nuts and screw connections.
Mounting holes