Install Instructions

2 Safety instructions

The installation and commissioning of the solar station as well as the connection of electrical

components requires technical knowledge matching with a recognized vocational qualification

as a pipe fitter for plumbing, heating and air conditioning technology, or a profession requiring a

comparable level of knowledge. The following must be observed during installation and

commissioning:

x the relevant state and national regulations

x the accident prevention regulations of the trade association

x the technical and safety instructions of these instructions

Attention: Risk of scalding

There is a danger of steam emission with safety valves. Therefore a

discharge pipe must be connected to the ¾" internal thread of the safety

assembly. Please observe the enclosed instructions regarding the safety

valve when doing this.

Attention: Damage to property

The group of fittings must be installed with sufficient spacing to the

collectors because temperatures in the vicinity of the collectors can be

very high. An intermediate vessel may be necessary for installation in the

attic.

Attention: Damage to property

It is imperative that you make sure the EPDM sealing elements of the

solar station do not come into contact with substances containing mineral

oil. Mineral oil products cause lasting damage to the material, whereby its

sealant properties are lost.

If necessary, ask the manufacturer whether the solar fluid, contains fats

or installation aids contain mineral oils.

We do not assume liability nor provide warranty for damage to property

resulting from seals damaged in this way.