Brochure

2
31
Code Description Lbs USD
NA546328T 1" sweat 6.8 540.00
NA546306T 1" FNPT 6.8 555.00
NA546366T 1" press 7.1 585.00
NA546335T 1¼" sweat 6.8 684.00
NA546307T 1¼" FNPT 6.8 707.00
NA546367T 1¼" press 7.1 773.00
Magnetic Dirt separator plus Boiler Chemical
Treatment Kit.
Brass body.
½" NPT top thread with plug.
Treats up to 30 gallons.
DIRTMAG
®
plus 1 can of Rhomar Hydro-Solv
TM
cleaner and 1 can of Pro-Tek
®
treatment.
Aerosols are injected into the hydronic system
through the GHT connection on the bottom of
the DIRTMAG
®
.
NA5463
Chemical kit
Code Description Lbs USD
NA545305
¾" NPT male union
4.5 295.00
NA545365 ¾" press union 4.5 320.00
NA545395 ¾" sweat union 4.5 293.00
NA545306 1" NPT male union 4.5 340.00
NA545366 1" press union 4.7 385.00
NA545396 1" sweat union 4.5 324.00
NA545355 ¾" NPT female union, isolation valves 5.5 354.00
NA545356 1" NPT female union, isolation valves 5.5 413.00
NA545376 1" press union, isolation valves 5.5 565.00
MAGNETIC DIRT SEPARATORS
NA5453
Dirt separator with magnet.
Brass mounting housing.
Composite PA66G30 body.
Max. working pressure: 45 psi.
Working temperature range: 32—195°F.
Particle separation capacity: to 5 µm (0.2 mil).
Ferrous impurities separation efficiency: 100%.
Drain valve with hose connection.
Top dosing point port.
Dosing capacity: 12 fluid oz.
Manual screw air vent.
The special coupling between the locking nut and the mounting base allows
the DIRTMAG
®
dirt separator to be rotated for installation to either vertical or
horizontal pipes, while maintaining the same operating performance.
The dirt separator with magnet combines the
action of the internal element and magnet. The
impurities in the water strike the internal element
and are separated, dropping into the bottom of
the body where they are collected.
Ferrous impurities are also trapped inside the
dirt separator body by two strong magnets
inserted into removable outer ring collar. The
collected impurities are discharged by removing
the external ring magnet and opening the drain
valve. This procedure can be performed while the
system is in operation.
MAXIMUM FLOW RATE
Size ¾" 1"
GPM 10 10
Cv w/ ball valve 9 9
Cv w/o ball valve 12 12
Construction
MAGNET
SERVICEABLE MESH
DRAIN VALVE WITH GHT FOR
AEROSOL INJECTION
LARGE
CHAMBER
AEROSOL CAN INJECTION CAP
CHEMICALS
Application
VENT
Rhomar cleaner used to clean/flush
system prior to commissioning, Rhomar
inhibitor added after fill/purge process.
Not permanently connected.
NEW
NEW