User Guide

Service Instructions
There is no service required for the SEP4™ 4-in-1 Air, Hydraulic, Dirt and Magnetic Separator.
CAUTION: Corrosion or leakage can cause damage or injury.
Periodically inspect for signs of corrosion or leakage. If corrosion or
leakage is note, the vent must be replaced. Failure to follow these
instructions could result in property damage and/or personal injury.
B
Procedure for installation and insulation assembly
1. Remove the two black head covers at the ends.
2. Open the two side sections.
3. Install the separator in the system.
4. For cooling applications, consider using a silicon caulk
or sealant by spreading a thin layer of sealant over
surfaces A and B.
Wait for the solvent to evaporate (approx. 10 minutes).
Note that once the sealant dries it may be difficult to
remove the insulation shell in the future without
destroying portions of the insulation.
5. Reassemble the two side sections.
6.
Finish the assembly with adhesive tape (not supplied).
7. Complete with the two black head covers.
A
Caleffi North America, Inc.
3883 West Milwaukee Road
Milwaukee, WI 53208
T: 414.238.2360 F: 414.238.2366
CALEFFI