Product Overview

CALEFFI
1
2 3
4
CALEFFI
1
2 3
4
1
2 3
4
1
2 3
4
CALEFFI
60"
4"
Installation
Thermostatic control heads should be installed in the horizontal position.
The sensitive element of the thermostatic control head must not be
installed in niches, alcoves, behind curtains or directly exposed to
sunlight, any of which would sense incorrect temperature values.
Before installing the thermostatic
control head, turn the control knob to
the number 5 position.
Locking and restricting the thermostat control temperature
Temperature restriction
Locking the temperature
Resetting the temperature restriction and temperature lock
Remote sensor control
Refer to the dimensions
shown to properly install the
thermostatic control head with
remote sensor, code 203502.
Tamper-proof cap
The thermostatic control head can be
protected against tampering and theft
by mounting the tamper-proof cap, code
209000, on the knob asshown.
The cover is fastened with two screws
with special heads that can only be
tightened or loosened with the special
hex key, code 209001.
1. Turn the knob to
the fully open position
(Pos. 5). Using a
screw-driver, unlock
the ring, pressing
it fully towards the
valvebody.
1. Turn the knob to
the fully open position
(Pos. 5). Using a
screw-driver, unlock
the ring, pressing
it fully towards the
valvebody.
1. Using a screw-
driver, unlock the
ring, pressing it
fully towards the
valvebody.
2. Turn the knob to
the new maximum
open position required
(e.g. Pos. 3). Turn
the ring counter-
clockwise up to
thestop.
2. Position the
valve at the required
temperature and turn
the ring clockwise up
to thestop.
2. Turn the knob to
the fully open position
and the ring counter-
clockwise, up to the
stop. The RESET
arrows will match up.
3. Re-lock the ring.
The valve will now have
a temperature range
restriction from 0 to the
set value.
3. Re-lock the ring.
Thevalve will now
be locked at the set
temperature.
3. Re-lock the ring.
Thevalve will now
no longer have any
temperature restriction
orlock.