Product Overview

2
19
MA&NETIC DIRT SEPARATORS
Code Description Lbs USD
NA545305 ¾" union NPT 4.5 266.60
NA545365 ¾" press 4.5 275.00
NA545395 ¾" union sweat 4.5 264.60
NA545306 1" union NPT 4.5 306.90
NA545396 1" union sweat 4.5 292.30
NA5453
tech. broch. 01240
Dirt separator with magnet.
Brass mounting housing.
Composite PA66G30 body.
Max. working pressure: 45 psi.
Working temperature range: 32—195°F.
Particle separation capacity: to 5 μm (0.2 mil).
Magnetite removal effi ciency: 95%
Drain valve with hose connection.
Top dosing point port.
Dosing capacity: 12 fl uid oz.
Manual screw air vent.
The special coupling between the locking nut and the mounting base allows
the DIRTMAG
®
dirt separator to be rotated for installation to either vertical or
horizontal pipes, while maintaining the same operating performance.
The dirt separator with magnet combines the
action of the internal element and magnet. The
impurities in the water strike the internal element
and are separated, dropping into the bottom of
the body where they are collected.
Magnetite impurities are also trapped inside
the dirt separator body by two strong magnets
inserted into removable outer ring collar. The
collected impurities are discharged by removing
the external ring magnet and opening the drain
valve, this procedure can even be performed
while the system is in operation.
FLOW RATE
Size ¾" 1"
4.0 f/s
GPM 8 9
10.0 f/s
GPM 14 20
Cv 12 19
Code Description Lbs USD
NA545355 ¾" union NPT with isolation valves 5.5 318.80
NA545356 1" union NPT with isolation valves 5.5 372.80
NA5453
tech. broch. 01240
Dirt separator with magnet.
Brass mounting housing.
Composite PA66G30 body.
Max. working pressure: 45 psi.
Working temperature range: 32—195°F.
Particle separation capacity: to 5 μm (0.2 mil).
Magnetite removal effi ciency: 95%
Union isolation ball valves.
Drain valve with hose connection.
Top dosing point port.
Dosing capacity: 12 fl uid oz.
Manual screw air vent.
2
nd
QT 2
015
2
nd
QT 2015
This multifunction device can also be used as an dosing point to inject
chemical additives into the circuit.
Use a screwdriver to undo the screw on the top plug in order to purge any
air that has collected at the top of the body.