User`s guide

b. To Enter and Store a Height:
i. If you are entering a height
(instead of rolling), press [Set]
[SQ/CU].
ii. If you do not want to change
the unit of measure, go to
step iii. To change the unit of
measure, press [M+] until you
reach the desired unit.
iii. Press [Scale] to begin setting
the digits. The left-most digit
will begin flashing.
Press:
[M+] to increment this digit
[Sub] to decrement the digit
[Scale] to advance to next digit
[Mode] to move back one digit
iv. Once you are finished setting
the digits, press [Set] anytime
to store the value as height.
The display will clear to zero.
Note: Once you set your height, you do not
need to enter it again unless you want to
change it.
4) To find volume, press [Sq/Cu]. The
first press calculates the area; press
the [Sq/Cu] key again to find vol-
ume. Press a third time to display
the value stored as Height.
29 – User’s Guide
UG6130E-C 4/4/03 12:39 PM Page 29