User`s guide

Setting an Auto-Count Value
The Scale Master II has an Auto-Count
mode that allows you to count how
many times you’ve rolled a certain dis-
tance. You will hear a beep each time
you roll that distance.
To program in Auto-Count mode:
1) Press [Set] [Count] to enter Auto-
Count programming mode. The
appropriate annunciator will begin
flashing “FT-IN” for Imperial Mode,
“MM” for Metric Mode. The Auto-
Count annunciator “AUTO”will ap-
pear in the scale box display.
2) If you want to change the units of
measurement, press [M+]. Repeat-
edly press this key until you reach
the desired unit of measurement.
Then press the [Scale] key to begin
setting the distance.
3) Press [M+] to increment the dis-
tance. When you have reached the
correct number, press [Scale] to ad-
vance to the next digit.
23 – User’s Guide
UG6130E-C 4/4/03 12:39 PM Page 23