Owner's manual

POCKET REFERENCE GUIDE — 19
KEYSTROKE DISPLAY
1. Enter finished Block width in Inches:
N N 0.
1 0 i B
SIZE 10 INCH
2. Enter Block height in Inches:
8 i c B HGHT 8 INCH
3. Enter number of Blocks Across:
3 A ACRSS 3. QTY
4. Enter number of Blocks Down:
4 D DOWN 4. QTY
5. Clear previously entered Sashing:
0 S* SASH 0 INCH WIDTH
6. Find total Block Yardage:
b TOTAL 0-7/8 YD
7. Find total number of Blocks:
b TOTAL 12. QTY
8. Find the number of Block strips:
b TOTAL 3. QTY STRIPS
9. Find Block cut width:
b**
TOTAL 10-1/2 INCH CUT WIDTH STRIPS
*Sashing values are not displayed since Sashing
was cleared.
**Continued presses of
b will repeat the
sequence above.
Note: You may also enter a Block’s size by enter-
ing the length times width, then press the
B
key. For example, if you have a 10 Inch (width) x
8 Inch (height) Block size, enter it as 1 0 x 8
B (10 INCH BLOCK WIDTH is displayed).